Jump to content
TUFLOW Forum
siripen_ace

Viewing flood extent and velocity vectors

Recommended Posts

I'm trying to view a flood extent with velocity vectors on but I'm struggling to show both parameters at the same time.

 

I turn on Functional Surface and Vectors in Display Options and I get a grid of functional surface as shown in the attached.

 

I've tried Contours but then I get contour lines instead of the surface contour. Without Vectors on the Functional Surface seem to show the result as extent and not grid.

 

Does anyone know what's the right way to view surface contour and vectors at the same time?

 

Many thanks.

post-44149-0-34286500-1432893263_thumb.j

Share this post


Link to post
Share on other sites

Hi Siripen,

 

This might just be a case of changing the method used to display contours. Under "Display Options", select the "Contours" tab. Under the "Contour Method", change this from the default of "linear" to "Colour Fill". 

 

The attached figure shows the results of a direct rainfall model I am reviewing where both "contours" and "vectors" have been selected under the "Display Options". 

post-270-0-60063200-1432904718_thumb.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...